227
the area of the instrument panel display
only when the following filters occur:
the additional fog signal will appear if
the front or rear fog lights are on;
the additional snow signal will appear
if the outside temperature is equal to
or lower than 3°C and the windscreen
wipers are working;
the additional rain signal will appear if
the windscreen wipers are working.
The no overtaking road sign
may
also be shown on the display.
In addition to the dedicated area of the
instrument panel display, the various
road signs detected by the system can
be shown in the Driver Assist area of
the instrument panel display (see the
“Display” chapter in the “Knowing the
instrument panel” section).
WARNING
291) The system only detects preset
traffic signs if the minimum visibility
conditions and distance from the sign are
met.
292) The system is an aid for driving
and does not relieve the driver of
responsibility for driving the car. Always
respect the highway code of the country
you are driving in.
293) When the system is active, the driver
is responsible for controlling the car and
monitoring the system, and must be ready
to intervene as appropriate if necessary.
IMPORTANT
91) Functionality may be limited or the
system may not work if the sensor is
obstructed.
92) The system may have limited
operation or not work at all in weather
conditions, such as heavy rain, hail, thick
fog and low temperatures. Strong light
contrasts can influence the recognition
capability of the sensor.
93) The area surrounding the sensor must
not be covered with stickers or any other
object.
94) Do not tamper or perform any
operations in the area of the windscreen
glass directly surrounding the sensor.
95) Clean the windscreen glass from
foreign matters such as bird droppings,
insects, snow or ice. Use specific
detergents and clean cloths to avoid
scratching the windscreen.
ISA (Intelligent Speed
Assist) system
(where provided)
The ISA system prompts the driver to
automatically adjust the speed limit
according to the speed limit for the road
ahead.
Warning
To enable the feature, it must be
enabled using the Uconnect™ system
settings. See the "Uconnect™" chapter in
the "Multimedia" section.
System ready
To activate the system, press the
button on the steering wheel fig. 231.
The system engagement signalled by the
white symbol
and a message on the
instrument panel display.
231 5520681D
Active system
Once the ISA system is engaged, it can
be activated at any time by pressing
the SET +, SET - or RES buttons on the
steering wheel.
To Next Page
Loading...
