STARTING AND DRIVING
232
WARNING
302) The driver is always responsible
for parking and other potentially
dangerous maneuvers. When making
these maneuvers, always make sure that
no people (especially children) or animals
are present in your maneuvering space.
The parking camera serves to assist the
driver, but he or she must always pay full
attention during potentially dangerous
maneuvers, even those executed at low
speeds. In addition, always proceed at a
moderate speed so as to be able to stop in
time if an obstacle is detected.
IMPORTANT
96) To work correctly, it is essential that
the camera is always free from mud, dirt,
snow or ice. When cleaning the camera,
take care not to scratch or damage it;
avoid the use of dry, rough or hard cloths.
The camera must be washed using clean
water, with the addition of car shampoo
if necessary. In washing stations which
use steam or high-pressure jets, clean the
camera quickly, keeping the nozzle more
than 10 cm away from the sensors. Do
not affix stickers on the camera.
CHARGING
(Plug-In Hybrid versions)
303) 304)
97)
Before charging the high-voltage battery,
it is recommended to turn the ignition
device to STOP in order to obtain a
charge until full in the shortest period
possible.
WARNING The brake calliper lock
is activated during the charging
procedure: unlocking will be carried out
automatically at the end of the charging
procedure.
CHARGING PORT ON THE CAR
233 5520614D
To access the charging port, open the
charging flap (1) fig. 233 on the left side
by pressing the area indicated by the
arrow.
WARNING The courtesy lights on the
charging port flap remain on for a few
seconds and turn off while charging.
Charging port LED
Next to the charging port there are
some LEDs (1) fig. 234 that indicate
the charging status by means of four
different colours and related flashing
types:
Blue: to indicate that the system is
waiting for a scheduled charging.
Green flashing : during the charging
process.
Steady green: to indicate that the
charging process is complete.
Red blinking: : to indicate a fault in the
charging system or when there is a fault
in the charging procedure (e.g. when the
charging connector is connected to the
charging port located on the car and the
cable has not been previously connected
to the power socket).
To Next Page
Loading...
