SERVICING AND MAINTENANCE
330
IMPORTANT
6) Used engine oil and oil filters contain
substances which are harmful to the
environment. To change the oil and
filters, it is advisable to contact a Jeep
Dealership.
CHARGINGTHE
CONVENTIONAL BATTERY
(only for petrol and diesel versions)
WARNINGS
WARNING After setting the ignition
device to STOP and closing the driver's
door, wait at least one minute before
disconnecting the electrical supply
from the conventional battery. When
reconnecting the electrical supply to the
conventional battery, make sure that the
ignition device is in the STOP position
and the driver's door is closed.
WARNING Charging should be slow at a
low ampere rating for approximately 24
hours. Charging for a longer time may
damage the conventional battery.
WARNING The cables of the electrical
system must be correctly reconnected to
the conventional battery, i.e. the positive
cable (+) to the positive terminal and
the negative cable (–) to the negative
terminal. The conventional battery
terminals are marked with the positive
(+) and negative (-) terminal symbols,
and are shown on the cover of the
conventional battery. The battery
terminals must also be corrosion-free
and firmly secured to the terminals. If a
"quick-type" conventional battery charger
is used with the battery fitted on the car,
before connecting it disconnect both
cables of the conventional battery itself.
Do not use a "quick-type" battery charger
to provide the starting voltage.
VERSIONS WITHOUT
STOP/START SYSTEM
To charge, proceed as follows:
disconnect the terminal from the
negative conventional battery pole;
connect the charger cables to the
conventional battery terminals, observing
the polarity;
turn on the battery charger;
when it is recharged, turn the charger
off before disconnecting it from the
conventional battery;
reconnect the terminal to the negative
conventional battery pole.
VERSIONS WITHSTOP/START
SYSTEM
To charge, proceed as follows:
disconnect the connector (1) fig. 334
(pressing the button (2)) from the sensor
(3) monitoring the battery conditions,
on the negative pole (–) (4) of the
conventional battery;
connect the positive cable (+) of
the battery charger to the positive
conventional battery terminal (5) and the
negative cable (–) to sensor terminal (4)
as shown in the figure;
turn on the battery charger.
At the end of the charging process,
switch the battery charger off;
after having disconnected the battery
charger, reconnect connector (1) to the
sensor (3) as shown fig. 334.
To Next Page
Loading...
