STARTING AND DRIVING
254
INTERRUPTINGTHE CHARGING
PROCEDURE
By inserting the charging connector of
the cable into the charging port on the
car, charging starts automatically.
Press the immediate recharge button
(1) fig. 265 to "by-pass" any recharge
programming already set on the
Uconnect™ system display (for further
information refer to what is described
in the "Uconnect™" chapter in the
"Multimedia" section.
To interrupt the charging, unlock the
doors by pressing the button
on the
key or the corresponding button on the
driver's door panel trim.
The LED (2) fig. 265 illuminates when
the car is charging without a set interval
or in the case of an immediate charging
operation.
If charging was interrupted, the LEDs (2)
turns off.
265 5520746D
If, approximately 60 seconds after the
doors are unlocked, the system detects
that the charging cable is still connected
inside the charging port, charging will
restart automatically and the cable will
be locked inside the charging port. A
dedicated message will appear on the
Uconnect™ system display.
NOTE The charging procedure can
be interrupted either while using the
"Mode 2" charging cable or while using
the "Mode 3" charging cable.
RESUMING THECHARGING
PROCEDURE
After interrupting the charging
procedure, if you wish to resume the
procedure, you can either perform
the door lock operation by pressing
the button
on the key or wait
approximately 60 seconds after the door
unlocking operation.
In this case, closing the doors with the
charging cable connected will resume
charging and the cable will be locked
inside the charging port.
Once the charging procedure is resumed,
the LED (2) next to the charging port will
turn off.
INSTANT CHARGING
MANAGEMENT
Instant charging is performed by
pressing the button (1) fig. 265 located
next to the charging port or through
the dedicated App installed on your
smartphone.
NOTE The (1) fig. 265 is only active
when the doors are unlocked.
END OF CHARGING PROCEDURE
The charging procedure ends when
all the LEDs (1) fig. 266, next to the
charging port, are on green continuously
(during charging, the first LED will
flash, while the other LEDs will be on
continuously).
266 5520743D
FAILURE DURING CHARGING
PROCEDURE
If a fault is detected during the charging
procedure, the first and last LED located
next to the charging port will light up
flashing red, fig. 267.
To Next Page
Loading...
Need help?
General
