253 5520618D
if no scheduled charging has been
set (see the "Charging functions"
chapter), charging starts automatically; If
scheduled charging has been set, press
the button (2) fig. 254 on the charging
port or use the dedicated App installed
on your smartphone.
check by turning on the LEDs on
the cable control unit that there are no
faults in the charging system (for more
information see "state of charge control
unit" chapter in the "Power sources that
can be used - Mode 2 cable" section). If
there are no anomalies, the green LEDs
located next to the charging port will
light up momentarily.
NOTE The charge procedure is
interrupted when opening the bonnet: a
dedicated message will be shown on the
instrument panel display. The charge will
be reactivated when the bonnet is closed
correctly.
The time required to charge the
high-voltage battery depends on several
factors: for more information see the
description in the “Charging time”
paragraph of in the “Multimedia"
section.
If the passenger compartment
preconditioning is activated, the
high-voltage battery charging time
will be extended. The time required
for heating/cooling the car is mainly
determined by the external temperature.
WARNING The maximum power
consumption of the charging port
depends on the type of contract signed
by the user, the type of cable used and
the state of charge set in the Uconnect™
system menu.
WARNING Use only the charging cable
supplied with the car or a replacement
cable recommended by FCA.
WARNING The high-voltage battery
must be charged in accordance with the
maximum amperage rating allowed by
local and national recommendations for
charging electric/hybrid vehicles.
END OF CHARGING PROCEDURE
The charging procedure ends when
all the LEDs (1) fig. 254, next to the
charging port, are on green continuously
(during charging, the first LED will
flash, while the other LEDs will be on
continuously).
To Next Page
Loading...
