STARTING AND DRIVING
258
274 5520875D
3. Ensure funnel is inserted fully to hold
flapper door open.
4. Pour fuel into funnel opening.
5. Remove funnel from filler pipe, clean
off prior to putting back in the spare
wheel storage area.
NOTES:
In certain cold conditions, ice may
prevent the fuel flap from opening. If
this occurs, lightly push on the fuel flap
to break the ice build-up and re-release
the fuel flap using the inside release
button. Do not pry on the flap.
When the fuel nozzle “clicks” or shuts
off, the fuel tank is full.
348) 349) 350) 351)
EMERGENCY FUEL FLAP
OPENING
(where provided)
If the fuel flap is not unlocked due to
faults in the electrical unlocking system,
the fuel flap can be unlocked manually
using a cord located on the right side of
the boot, on the side panel near the fuel
flap.
1. Open the liftgate.
2. Remove package tray if equipped.
3. Remove the access flap (1) fig. 275
located on right interior trim panel to
release the cable with the tip of your key.
275 5520250D
4. Grab the release cable tether fig. 276
and gently pull up to unlock the fuel
filler flap.
NOTE Excessive force may break cable
tether.
NOTE If refuelling is performed by
manually unlocking the fuel flap, special
attention must be paid to the reference
operation as the fuel may flow back.
276 5520655D
5. Push on the outer edge fig. 269 to
open the fuel filler flap.
TOPPING UP AdBlue
®
DIESEL
EMISSIONS ADDITIVE
(where provided) (Diesel versions only)
352)
Preliminary Conditions
AdBlue
®
freezes at temperatures lower
than -11°C. If the car stands for a long
time at this temperature refilling could
be difficult. For this reason, it is advised
to park the car in a garage and/or heated
environment and wait for the AdBlue
®
to
return to liquid state before topping up.
Proceed as follows:
park the car on flat ground and stop
the engine by setting the ignition device
in the OFF position;
open the fuel flap and then unscrew
and remove the cap (1) (blue) from the
AdBlue
®
filler.
To Next Page
Loading...
