309
129)
Using the towing attachment
The car is equipped with a tow eye
fig. 326 which can be used to move it if
it breaks down.
If a towing attachment is used, make
sure to follow the instructions in
"Precautions for using the towing
attachment" and "Towing a broken-down
car" in this section.
326 5520455D
Precautions for using the towing
attachment
130) 131) 132) 133) 134)
Towing attachment warning label
327 0614050352
408) 409) 410) 411) 412)
Fitting the towing attachment - Front towing
attachment
The front towing attachment housing
is located behind a flap on the front
bumper (fig. 328)
To fit the attachment, open the flap
using the car key or a small screwdriver,
then tighten the attachment in its
housing.
Insert the flat end of the jack handle
through the tow eye and tighten, refer
to “Replacing a wheel” in this section
for further information. The towing
attachment must be completely inserted
in the respective fastening bracket
through the lower part of the front
bumper. Do not tow the car if the towing
attachment is not completely inserted in
the fixing bracket.
328 5520731D
Fitting the towing attachment - Rear towing
attachment
The rear towing attachment is located
behind a flap behind a flap on the rear
right side of the bumper (fig. 329).
To fit the attachment, open the flap
using the car key or a small screwdriver,
then tighten the attachment in its
housing.
Insert the flat part of the jack lever in
the towing attachment and tighten. The
towing attachment must be completely
inserted in the respective fastening
bracket through the lower part of the rear
bumper. Do not tow the car if the towing
attachment is not completely inserted in
the fixing bracket.
To Next Page
Loading...
