57
52 5520328D
NOTE Use the door lock button from the
inside or on the key to close the liftgate.
Closing the doors using the outer latch
does not lock the liftgate.
WARNING Before closing the boot make
sure that you have the keys, since the
boot is automatically locked.
BOOT INITIALISATION
If the conventional battery is
disconnected or the protection fuse
blows, the boot opening/closing
mechanism must be reinitialised as
follows:
close all the doors and the boot;
press the button on the remote
control;
press the button on the remote
control.
ELECTRICALLYOPERATED
LIFTGATE
(where provided)
The power liftgate can be opened or
closed with the key, the exterior handle,
the switch on the overhead console (1)
fig. 53 (where provided) and the liftgate
switch (2) fig. 54 (where provided) on
the upper left trim.
53 5520329D
54 5520340D
Using any of the above ways:
When the liftgate is fully closed, the
liftgate will open.
When the liftgate is fully open, the
liftgate will close.
When the liftgate is moving, the
method will be reversed.
The key and the switch on the overhead
console will open the liftgate when the
liftgate is locked. The liftgate must be
unlocked to open it using the external
handle. Push the button on the key
twice within five seconds to open or
close the liftgate.
When the
button on the key is
pressed twice, the direction indicators
will flash twice to signal that the liftgate
is opening or closing (if "Flash Lamps
with Lock" is enabled in the Uconnect™
settings) and an acoustic warning will be
heard. Refer to the “Settings” chapter
in the “Multimedia” section for further
information.
Unlock the car
70)
NOTES:
The power liftgate will not open or
close if the gear lever is in gear engaged
position or the car speed is above
0 km/h.
If anything obstructs the power liftgate
while it is closing or opening, the liftgate
will automatically reverse to the closed
or open position, provided it meets
sufficient resistance.
There are also pinch sensors attached
to the side of the liftgate opening. Light
pressure anywhere along these strips will
cause the liftgate to return to the open
position.
If the power liftgate encounters
obstructions within the same cycle, the
system will automatically stop. If this
occurs, the liftgate must be opened
To Next Page
Loading...
