59
if the liftgate was stopped, another
movement of the foot reverses the
direction and opens it completely.
You can activate/deactivate the
automatic liftgate opening and closing
function in “Hands Free” mode on the
Uconnect™ system by activating the
Main menu and selecting the following
items in sequence: "Settings", "Doors
and Locks" and "Automatic liftgate
opening".
WARNING Before lifting the foot off
the ground, make sure that you are
in stable position. Do not touch any
part of the car. There is a risk of injury
from touching, for example, the very hot
exhaust system.
WARNING To safeguard the charge
of the conventional battery, avoid
repeatedly performing this operation
while the engine is stopped.
WARNING To prevent accidentally
opening the liftgate when washing the
car at a car wash station or using a high-
pressure cleaner, use the Uconnect™
system to disable the “Boot automatic
opening” function.
LOAD COMPARTMENT
FEATURES
Removable rear shelf
(where provided)
Proceed as follows to remove the rear
shelf:
1. Disconnect the two rods (1) fig. 56
that support the shelf at the eyelets.
56 5520638D
2. Through a rear door, lift the part of
the rear shelf closest to the rear seats.
3. Remove the pins located on the
outside of the shelf, then remove the rear
shelf by pulling it upwards and pulling it
out of the rear door.
4. The rear shelf can be stowed in the
load compartment or behind the front
seat backrests.
Rear shelf adjustment
57 5520637D
Rear shelf pin
58 5520639D
Load platform
The load platform has a load capacity
of 181 kg, to be understood distributed
over the entire surface.
Reconfigurable load platform
The load platform can be adjusted to
three different levels to create more
space in the load compartment. These
positions are: upper (1), middle (2) and
lower (3) fig. 59.
NOTE The lower position is not available
in vehicles equipped with either a
space-saver spare wheel or a full-size
spare wheel. The centre position is not
available in vehicles equipped with a
full-size spare wheel.
To change the level of the load platform,
pull upward on the load platform handle,
pull the floor outward, and place the
back of the platform into the desired
position. Lower the front of the platform
into place.
To Next Page
Loading...
