89
Warning Light/Symbol What it means
EBD FAILURE
The simultaneous switching on of the warning lights or symbols
(red) and (amber) with the engine on indicates
either a failure of the EBD system or that the system is not available. In this case, the rear wheels may suddenly lock
and the vehicle may swerve when braking sharply.
Drive very carefully to the nearest Jeep Dealership to have the system inspected immediately.
POWER STEERING FAILURE
If the warning light or symbol remains on, you could not have power steering and the effort required to operate the
steering wheel could be increased; steering is, however, possible.
Contact a Jeep Dealership as soon as possible.
85)
SEAT BELTS REMINDER
The warning light switches on fixed and an acoustic warning will sound if the car is stationary and the driver side or
passenger side seat belt, with the passenger seated, is not fastened. The warning light flashes or switches on fixed,
and an acoustic warning will sound if the car is moving and the driver side or passenger side seat belt, with the
passenger seated, is not correctly fastened. In this case, fasten the seat belt.
Refer to the “Occupant Restraints Systems” chapter in the “Safety” section for more information.
SECURITY ALARM
(where provided)
The warning light flashes quickly for approximately 15 seconds when the security device is enabled and it then flashes
more slowly until the car is unlocked.
ALTERNATOR FAILURE
The switching on of the symbol with engine on corresponds to an alternator failure. Contact a Jeep Dealership as soon
as possible.
DOORS OPEN
The symbol switches on when one or more doors are not completely shut. An acoustic signal is activated with the
doors open and the car moving. Close the doors properly.
To Next Page
Loading...
Need help?
General
