Jensen CD-565 - Power Source and Operation; Control Identification; AC Power Operation; Battery Power Operation

E7
1 VOLUME CONTROL 11 SOURCE BUTTON
2 POWER BUTTON 12 TUNING CONTROL KNOB
3 MEMORY- BUTTON 13 TELESCOPIC ANTENNA
4 MEMORY+ / RANDOM PLAY BUTTON 14 CD DOOR OPEN
5 REPEAT BUTTON 15 AUX IN JACK
6 FM STEREO INDICATOR 16 HEADPHONE JACK
7 LCD DISPLAY 17 BATTERY DOOR
8 PROGRAM/MEMORY BUTTON 18 DC IN JACK
9 STOP BUTTON 19 BUILT-IN HANDLE
10 PLAY/PAUSE / PAIR BUTTON
POWER SOURCE
This unit operates using the included AC Adaptor or using 6 x 1.5VDC “C” (UM-2) batteries (not
included). Do not attempt to operate the unit on any other power source. You could cause damage to
the unit and void your warranty. Please be sure the power outlet you plug this unit into is working and
receives constant (unswitched) power.
AC OPERATION
An AC Adaptor with 5V DC, 1000 mA output voltage is included and is required for operating
this in AC power mode”
1. Securely insert the DC plug of the adaptor cord into the DC Jack located on the back of
the unit.
2. Plug the AC Adaptor into a 120V AC wall outlet.
3. Connecting this unit to any other power source may cause damage to the unit.
4. Press the POWER button located on the top of the unit to turn the unit ON.
5. The LCD display will light.
Note: Unplug the AC adaptor from the unit and the wall outlet if you’re not going to be using it
for an extended period of time.
BATTERY OPERATION
Unplug the AC adapter from the wall and from the unit prior to installing the batteries (not
included).
1. Remove the battery door located on the back of the unit.
2. Following the polarity diagram located inside the battery compartment, install the 6 x 1.5VDC “C”
(UM-2) batteries (not included).
Note: For best performance, alkaline-type batteries are recommended.
DC 5V
1.2A
AUX IN
OPEN OPEN
REAR VIEW