What to do if my Jensen VM9414 won't turn on?
If your Jensen Car Receiver isn't powering on, there are a few potential causes. First, check if the radio fuse or the car battery fuse has blown, and if so, install a new fuse with the correct rating. Alternatively, the unit may be in an illegal operation state; if this is the case, press the RESET button located in the bottom right corner of the front panel.
Jensen VM9414 remote control not working, what to do?
If your Jensen Car Receiver remote control is not functioning, the battery may be depleted; replace it with a new one. Also, ensure the battery is installed correctly by removing it and reinstalling it properly.
What causes flashing images on my Jensen Car Receiver?
A flashing image or interference on your Jensen Car Receiver screen can occur if the DVD is not compatible with the current TV system settings; change the setup to accommodate the disc. Additionally, improper video signal connections can cause this issue, so check the wiring and correct it if necessary.
Why does my Jensen Car Receiver keep resetting when the engine is off?
If your Jensen Car Receiver resets itself when the engine is off, it could be due to an incorrect connection between the ACC and positive battery wire. Check the wiring and correct it.
Why is there no image on my Jensen VM9414 Car Receiver screen?
If there is no image on your Jensen Car Receiver screen, check the wiring and correct any incorrect connections to the parking brake wire. Also, ensure that the parking brake is engaged by stopping the vehicle in a safe place and applying the parking brake.
How to improve weak station searching on my Jensen VM9414 Car Receiver?
To improve weak station searching on your Jensen Car Receiver, make sure the auto antenna is fully extended and properly connected by checking and correcting the auto antenna control cable connection. Also, ensure that the LOCAL function is turned off.
Why does my Jensen Car Receiver have poor sound quality?
Poor sound quality or distortion in your Jensen Car Receiver could be due to several reasons. Using a pirated disc can cause this, so use an original copy. Ensure that the speaker power rating is compatible with the unit, and connect proper speakers if necessary. Also, check the speaker contact for any shorts.
What to do if my Jensen VM9414 Car Receiver disc does not play back?
If your Jensen Car Receiver is not playing discs, consider these possible causes: The disc may be warped or scratched, so use a disc in good condition. If the disc is dirty or wet, clean it with a soft cloth. The laser pickup might be dirty, requiring cleaning with a cleaning disc. Ensure you are using a compatible disc and that the disc region code is compatible with the unit. If the disc rating exceeds the Parental Lock rating limit, change the Parental Lock settings to a lower restriction. Lastly, make sure the disc is inserted with the label side up.
Why is there no sound coming from my Jensen VM9414?
If you're experiencing no or low audio output from your Jensen Car Receiver, several factors could be the cause. Check the wiring for improper audio output connections and correct them if necessary. Ensure the volume isn't set too low by increasing the volume level. Review the wiring diagram to check the “MUTE” connection. Damaged speakers can also cause this issue, so consider replacing them. Heavily biased volume balance can lead to low output, adjust the channel balance to the center position. Finally, ensure speaker wiring is not in contact with any metal part of the car by insulating all speaker wiring connections.
General| Display Size | 6.2 inches |
|---|---|
| Touchscreen | Yes |
| Bluetooth | Yes |
| USB Port | Yes |
| SD Card Slot | Yes |
| Radio Tuner | AM/FM |
| DVD Player | Yes |
| Navigation | No |
| CD Player | Yes |
| Aux Input | Yes |
| Rear View Camera Input | Yes |
| Video Output | Yes |
| Max Power Output | 200 watts |
| Display Resolution | 800 x 480 |
| Video Playback | Yes |
| Peak Output | 50 watts x 4 channels |
To Next Page
