JENSEN"
XCH 6RF
Installation
Before
You
Begin Installation
Before you begin, you will need tools, supplies
and
adapters.
It
is
best
to
make sure you have
everything you need before you begin.
Tools
and Supplies
Needed
• Hand tools
• Supplies for making wire connections
(electrical tape, twist-type wire connec-
tors, or crimp-on terminals; for best
results, make soldered
connections)
• Power tools (to drill holes to mount
compact disc changer to vehicle)
Disconnect Battery
Before you begin,
disconnect the battery
negative terminal.
Adapters
for
Easier
Installation
2
1990 and newer GM cars have a small
antenna connector.
You
will need two adapt-
ers when installing this
CD
changer
in
a
newer GM
car.
Prepare
CD
Changer
for
Installation
Remove Shipping Screws
The
XCH
6RF compact disc changer
is
shipped with the shock-absorbing mechanism
secured.
Remove the shipping label and 4 shipping
screws from the sides of the compact disc
changer before installation. Keep the screws,
as they will
be
required
if
you transport the
player again.
""
Label
Cover the screw holes with round self-adhe-
sive labels.
Install Door
Install the door by sliding
on
from the right.
To Next Page
Loading...
