Jensen XCD 9020 - Troubleshooting

JENSEN'
XCH 6RF
~ Troubleshooting
Problem
Cause Correction
CD changer does not
Fuse blown locate and replace fuse
operate
Bad ground to CD changer locate and repair ground
CD changer overheated Allow air to circulate around changer
Magazine not installedino discs Install discs and magazine
in magazine/discs installed
incorrectly
Disc is playing but there is Poor connections to FM Correct connections at modulator, CD changer
no sound modulator and receiver
Bad ground on FM modulator locate and repair ground connection
Fuse blown locate and replace luse
Receiver not tuned to correct Tune recelver
station (88.7 or 89.1 FM)
Condensation (moisture) on Remove magazine, leave CD changer door
CD changer laser optics (occurs open and wait approximately one hour
in humid, rainy conditions or
aner turning on the heater)
Music "skips" excessively
Shipping screws not removed
Remove shipping screws
when going over bumps
VerticaVilorizontal position not
Select position
selected correctly
Unit installed at an angle more Reinstall properly
than 15 degrees lrom vertical
or horizontal
"EOr, "E02", "E03" or "E06"
Disc loading or eject Press "RESET' button
appears on display
malfunction Insert a disc and try again
"E08" appears on display
Disc dirty
Clean the disc
Disc inserted incorrectly Insert the disc correctly
Can't find problem
Contact Jensen Technical Assistance
(1-800-323-0221 )
6