3. Thread nul (A)
Fig.
19, onto threaded
end
of rod
(B)
and
thread rod (B)
into
the hale 'provided in the
trunnion bracket (C) as shown.
If
necessary a rod or
pin can
be
placed
into
hole (D)
to
assis!
in
providing
leverage
when
threading the rod (B) into the trunnion
bracket. Then tighten
nul
(A) against trunnion bracket
(C),
as
Shawn.
4. Assemble bracket (A)
Fig.
20,
to
bracket (B) using
the screw, nul
and
lockwasher (C). Assemble the screw,
nul
and
Jockwasher (D)
to
bracket (A) as shown.
s.
Place bracket (B)
Fig.
20
on
rod (E) as shown,
and
fasten using the screw and
nul
(F).
6. Assemble the center portion of the
splitter
to
ihe
splitter
bracket (D)
Fig.
18,
and
replace
splitter
bracket
holder (A)
Fig.
18.
7.
Remove nul,
screw
and
lockwasher (B)
Fig.
21,
from the rear
splitter
bracket and assemble the
splitter
(A) to the bracket using the screw, nul and lockwasher
(B).
s.
Replace saw blade and using a straight edge make
sure the
splitter
(A)
Fig.
21, is in alignment
with
the
saw blade,
as
shown. If necessary, the rear mounting
bracket assembly (C) can
be
adjusted
to
bring the
splitter
into alignment
with
the saw blade. ,
Fig.
21
9
To Next Page
Loading...
