Jet JCS-10 User Manual

ASSEMBLING STAND
If you purchased the Stand assemble the stand
as shawn in Fig. 3,
1
using the Scr\3ws and nuts
supplied. On/y tighten the screws and nuls linger
tight at this time. NOTE: Fig. 4, illustrates the
proper re/ationshlp of the screws and nuts to the stand.
Place the stand on a leve/ surface and tighten the
screws
and nuts,
Fig. 3
ASSEMBLING SAW TO STAND OR BENCH
Assemble the saw to the Steel Stand. IMPORTANT:
If the saw is to be used without the Steel Stand. We
suggest that it a/ways be fastenec to a supporting surface
using the ho/es on the bottom Jedge of the saw cabinet.
FASTENING STAND OR BENCH TO FLOOR
IF DURING OPERATION THERE IS ANY TENDENCY
FOR THE TOOL TO TIP OVER. SLIDE OR WALK
ON. SUPPORTING SURFACE, THE STAND OR BENCH
MUST BE SECURED TO THE FLOOR.
4

Jet JCS-10 Specifications

General

Brand	Jet
Model	JCS-10
Category	Saw
Language	English