Jet JWS-18HO - Spindle and Fence Adjustments

SHAPER CUTTER INSTALLATION
1. Disconnect machine from the power source.
2. Raise the spindle fully.
3. Set the shaper cutter on the arbor with the
cutter rotating in the proper direction.
4. Put a space washer onto the arbor to reach
the proper height. Next, place the keyed
collar onto the arbor.
5. Place the washer on top and then tighten
the arbor screw.
SPINDLE CONTROL
To raise or lower spindle:
1. Loosen spindle lock knob (A). See figure
16.
2. Raise or lower spindle to desired height by
turning handwheei (B).
3. Tighten spindle lock knob.
FENCE ADJUSTMENTS
1. Adjust fence halves by loosening lock knob
(A), turn knurled knob (B) to adjust fence
in or out, and tighten lock knob.
See Figure 17.
2. Adjust spindle guard height by loosening
wing nut (C), sliding guard up or down to
desired height, and then tightening wing
nut.
3. Adjust spindle guard depth by loosening
two lock knobs (D), moving spindle guard
to desired position, and then tightening
two lock knobs.
4. Hold down clamps can be adjusted for
height by turning screw handle (E), to
loosen, adjust to desired height, and
tighten screw handle.
—6