Jet JWS-18HO - Lubrication

The work will now be supported by the
collar and starting pin.
2. After the cut has been started, the work is
swung free of the starting pin and rides
only against the collar as shown in the
third position in figure 29. Always feed
against the action of the cutter.
LUBRICATION
To insure easy movement when raising and
lowering spindle, occasionally apply a drop of
light oil on outside of spindle cartridge.
Spindle cartridge bearings are prelubricated and
sealed. They need no further care.
Cutter
starting Pin
Cutter
Starting Pin
Cutting Circle
Collar
Work
2rd Position
Fig. 28
2nd Position
3rd Position
Cutting Circle
Collar
Fig. 29
-9-