To Next PageTo Next Page
Need help?Do you have a question about the Jeti Duplex and is the answer not in the manual?
General| Brand | Jeti |
|---|---|
| Model | Duplex |
| Category | Control Systems |
| Language | English |
Technical specifications for Duplex receivers outside the US, part 1.
Technical specifications for Duplex receivers outside the US, part 2.
Technical specifications for Duplex receivers for the US market, part 1.
Technical specifications for Duplex receivers for the US market, part 2.
Details on how to connect and manage voltage supply for Duplex receivers.
Recommended procedure for switching Duplex receivers on and off.
Procedure for binding Duplex receivers to transmitters using a bind plug or JETIBOX.
Details on EX Telemetry data display with DC/DS transmitters and JETIBOX profi.
Instructions for using 1st Generation Telemetry with TU, TG, TF modules.
Guide to setting up receivers using the JETIBOX (direct or wireless connection).
Instructions for receiver setup using DC/DS transmitters, referencing the transmitter manual.
Explains receiver type, pairing, RX/TX IDs, and Rx Diag.
Read out measured receiver voltage data (max, min, actual).
Configure Fail Safe, Signal Fault Delay, voltage alarms, output period, serial link, and communication modes.
Setup of physical receiver outputs, including servo, PPM, digital, and input configurations.
Loads a default receiver configuration from preset modes.
Example of classic receiver setup for analogue/digital servos with specific parameters.
Example of classic receiver setup for digital servos with specific parameters.
Example setup for using a second receiver as a backup in clone mode.
Example setup for receivers using PPM output, including pos./neg. settings.
Example setup of PPM output for backup receivers like RSAT2 settings.
Example setup for receivers using EX Bus output, for JETI devices.
Example setup for receivers using UDI output, for VBar connection.
