Jeti Duplex - 6.4 Out Pin Set

computer radio control system
Bind process in clone mode (Attention!!! Change since FW
version 3.10!):
1. Switch the receiver to clone mode (MeasureOrSetting-
>Main Setting->RX mode: clone).
2. Switch off the receiver and insert a bind plug into the Ext.
socket.
3. Switch on receiver and transmitter. The transmitter announces
detection of a new receiver by an acoustic signal. Remove the
bind plug.
Telemetry* -unidirectional communication is usable exclusively for
telemetry transmission, for instance with the US version of the
JETIBOX profi.
This setup change requires longer pressing (press and hold) of the left
or right push button. The receiver mode change is only accessible via
the JETIBOX, see the Receiver setup chapter.
If you switch the receiver to clone or Telemetry modes, further
wireless setup communication becomes impossible because the
receiver is now communicating only unidirectionally. In order to
change the mode or setup, you have to connect the JETIBOX to the
receiver and make the desired change or switch the receiver back
toNormal mode:
1. Insert BIND PLUG into the receiver socket labeled Ext.
2. Switch on receiver
3. Switch on transmitter
4. Execute the desired setup changes, see Receiver setup
* Setup valid only for US receivers (firmware version 3.11)
EN
20
JETI model s.r.o.
Lomená 1530, 742 58 Píbor
Czech Republic - EU
www.jetimodel.com
www.jetimodel.de
info@jetimodel.cz
Main Advantages of the
DUPLEX-System:
 digital data transfer
 system without crystals
 safe operation
 real time telemetric data transfer
 two receiver antennas
 response of receiver exits without time delay
 simultaneous operation of several receivers
with one Tx module
 acoustical signalling of the complete system
status
 parameter set-up with the aid of the JETIBOX
terminal
Hauptvorteile des DUPLEX-Systems:
 digitale Datenübertragung
 System ohne Quarze
 sicheres Betriebsverhalten
 Übertragung von telemetrischen Daten in
Realzeit
 zwei Empfängerantennen
 ansprechen der Empfängerausgänge ohne
Zeitverzögerung
 gleichzeitiger Betrieb mehrerer Empfänger
an einem Tx-Modul
 akustische Signale geben Auskunft über den
Zustand des Systems
 Parametereinstellung mit Hilfe des JETIBOX-
Terminals
Duplex-System EX:
 Transmitter modules
 Receivers
 Telemetric sensors
 Compatible accessories
 Display units
Duplex-System EX:
 Sendermodule
 Empfänger
 Telemetrische Sensoren
 Kompatibles Zubehör
 Abbildungseinheiten
radio control system
®
radio control system
extended serie
User Manual ... 01User Manual ... 01User Manual ... 01
Bedienungsanleitung ... 33Bedienungsanleitung ... 33Bedienungsanleitung ... 33
EN
DE
Receivers Receivers FW 3.22FW 3.22Receivers FW 3.22
Empfänger Empfänger FW 3.22FW 3.22Empfänger FW 3.22