JGR RL1 - Page 39

RL1 User Manual
33
M-RL1-001-01
Table 12: RL1 commands list
Command
Description
LASer:DISABle
Disable all lasers (equivalent to LASer:ENABle 0).
LASer:ENABLE #
Turn on laser at <nominal wavelength> in IL mode.
LASer:ENABle?
Return nominal wavelength of enabled laser.
LASer:INFO?
Return a list of supported nominal laser frequencies.
FIBER:INFO?
Return the type of fiber (SM or MM).
READ:RL? #
Return RL
A
, RL
B
, RL
TOTAL
and Length at <nominal wavelength>.
READ:RL? #,#,#
Return RL
A
, RL
B
, RL
TOTAL
and Length at <nominal wavelength, reference
length A, reference length B> .
REF:RL #
Set <length> of MTJ1 for the current channel (use output and/or
switch commands to set the current channel).
REF:RL?
Return MTJ1 length stored in the RL1 for the current channel (use
output and/or switch commands to set the current channel).
POW:det#:INFO?
Return serial number, calibration date, FW version, battery level, and
connection type for paired detector <#>.
POW:NUM?
Return total number of connected power meters.
READ:POW:det#? #
Return power meter reading for detector <#> at <nominal
wavelength>.
READ:POW:MON? #
Return internal reference power meter reading at <nominal
wavelength>.
READ:IL:det#? #
Return IL from detector <#> at <nominal wavelength>.
REF:IL:det# #,#
Set IL reference for detector <#> at <nominal wavelength, value>.
REF:IL:det#? #
Return IL reference for detector <#> at <nominal wavelength>.
READ:FACTory:POWer?
#,#
Return factory stored absolute power values at <output, nominal
wavelength>.
RL:SENSitivity #
Set RL sensitivity: <fast> or <standard>.
RL:SENSitivity?
Return RL sensitivity.
RL:POSB #
Set where RL
B
position is defined from <eof> (backward from end of
fiber) or <zero> (forward from position zero).
RL:POSB?
Return where RL
B
position is defined (default: eof).
DUT:LENGTH #
Set DUT length bin: <standard> (< 300m) or <long> (<3km)
DUT:LENGTH?
Return DUT length bin.
DUT:IL #
Set <DUT IL>. RL
B
will be compensated by this value.
DUT:IL?
Return the set value for DUT:IL. Note: this is not a measured value.
OUT:CLOSe #
Set the internal switch (SW0) to channel <#>.
OUT:CLOSe?
Return current internal switch (SW0) channel.
SW#:INFO?
Return the type of switch number <#> (SW0 for internal).
SW#:CLOSe #
Set switch number <#> to channel <#>.
SW#:CLOSe?
Return current channel of switch number <#>.
LCL #
Set local interaction mode: <1> (enabled) or <0> (disabled).
LCL?
Return local interaction mode status.
AUTO:ENABle #
Set auto-start mode: <1> (enabled) or <0> (disabled).