Section 7 - Lubrication and Maintenance
7-131200345
SECTION 7 - LUBRICATION AND MAINTENANCE
7.1 INTRODUCTION
Service the product in accordance with the Operation & Safety Manual supplied with
telehandler and the maintenance schedule on the following pages.
Clothing and Safety Gear
• Wear all the protective clothing and personal safety devices issued to you or called for
by job conditions.
• DO NOT wear loose clothing or jewelry that can get caught on controls or moving
parts.
7.2 GENERAL MAINTENANCE INSTRUCTIONS
Prior to performing any service or maintenance on the telehandler, follow the
shut-down procedure on page 4-3 unless otherwise instructed. Ensure telehandler
is level, for proper fluid readings.
• Clean lubrication fittings before lubricating.
• Apply a light coating of engine oil to all linkage pivot points.
• Intervals shown are for normal usage and conditions. Adjust intervals for abnormal
usage and conditions.
WARNING
CUT/CRUSH/BURN HAZARD. Do not perform service or maintenance on the machine
with the engine running, with the exception of the transmission oil level check.
To Next Page
Loading...
