JLG 4017PS - Page 65

Index
131200345
A
Additional Checks .............................. 8-1
Approved Platforms ........................... 5-1
Auxiliary Power System ...................... 6-2
Test.............................................. 8-1
B
Battery............................................... 7-8
Boom Joystick.................................... 3-4
C
Capacity ............................................ 5-2
Chemical Hazards............................... 1-9
Control Operation .............................. 4-3
Controls............................................. 3-2
D
Decals ............................................... 2-3
Dimensions........................................ 9-2
E
Electrical Hazards ............................... 1-2
Emergency Lowering of Boom ............ 6-2
Emergency Operation ........................ 6-1
Emergency Procedures....................... 6-1
F
Fall Hazard......................................... 1-8
Fuel Level .......................................... 7-4
G
Gate ................................................ 2-10
General Maintenance ......................... 7-1
H
Hazard Classification System............... 1-1
I
Incident Notification........................... 6-3
Indicator Panel................................... 3-3
Installation......................................... 5-3
L
Lanyard Anchorage Points.................2-11
Lifting Personnel.................................1-5
Load Falling Hazard ............................1-4
Lubrication and Maintenance ..............7-1
M
Minimum Approach Distance ..............1-2
N
Normal Engine Operation....................4-2
O
Operational Check ..............................2-9
Operator Maintenance Instructions......7-4
P
Performance.......................................9-1
Pinch Points and Crush Hazards...........1-6
Platform .............................................5-1
Platform Extension............................2-12
Platform Operation .............................4-2
Power/Emergency Stop Switch............3-2
Pre-Operation Check and Inspection....2-1
Preparing Machine for Platform
Operation...........................................4-1
S
Safety Decals ......................................2-3
Safety Practices...................................1-1
Safety Signal Words ............................1-1
Service and Maintenance Schedule
10 Hour.........................................7-2
1000 Hour .....................................7-2
50 Hour.........................................7-2
Shut-Down Procedure.........................4-3
Specifications .....................................9-1
Starting the Engine .............................4-2
Supplemental Information ..................9-3
Index