JLG E400A Narrow - Section 7: General Specifications & Operator Maintenance; 7.1 Introduction; 7.2 Operating Specifications

SECTION 7 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121716 7-1
SECTION 7. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
7.1 INTRODUCTION
This section of the manual provides additional necessary infor-
mation to the operator for proper operation and maintenance of
this machine.
The maintenance portion of this section is intended as informa-
tion to assist the machine operator to perform daily maintenance
tasks only, and does not replace the more thorough Preventive
Maintenance and Inspection Schedule included in the Service
and Maintenance Manual.
Other Publications Available:
Service and Maintenance Manual.............................................3121717
Illustrated Parts Manual ................................................................3121718
7.2 OPERATING SPECIFICATIONS
Table 7-1. Operating Specifications
Maximum Work Load (Capacity)
AN SI Ma rket s
U nrest ric ted: 50 0 lb. (2 27 kg )
Maximum Work Load (Capacity)
CE & Aus tral ia M arket s
U nrest ric ted: 50 0 lb. (2 30 kg )
Maximum Travel Grade, Stowed Position
(Gradeability)
2 W/D-30%
Maximum Travel Grade, Stowed Position
(Side Slope)
5 degrees
Platform Height: 40 ft. (12.19 m)
Horizontal Platform Reach (Up & Over)
E4 00A n
E/ M40 0AJ P; E/ M400 AJ Pn
21 ft.-2 in. (6.41 m.)
22 ft.-5 in.(6.8 m.)
Machine Width:
E/ M40 0AJ P
E400An; E/M400AJPn
5 ft.-9 in. (1.75 m.)
4 ft.-11 in. (1.50 m.)
Turning Radius (Outside) 10 ft.-4 in. (3.15 m.)
To order go to Discount-Equipment.com