SECTION 7 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121716 7-5
Torque Specifications Hydraulic Oil
NOTE: Hydraulic oils must have anti-wear qualities at least to API Ser-
vice Classification GL-3, and sufficient chemical stability for
mobile hydraulic system service.
Aside from JLG recommendations, it is not advisable to mix oils
of different brands or types, as they may not contain the same
required additives or be of comparable viscosities. If use of
hydraulic oil other than Mobil DTE 10 is desired, contact JLG
Industries for proper recommendations.
Table 7-5. Torque Requirements
Description Torque Value Interval Hours
Wheel Lugs 170 ft. lbs.
(230 Nm)
150
Swing Bearing
((Loctite)
190 ft. lbs.
(260 Nm)
50/600*
* Check swing bearing bolts for security after first
50 hours of operation and every 600 hours thereaf-
ter.
Table 7-6. Hydraulic Oil
Hydraulic System
Operating
Temperature Range
S.A.E. Viscosity
Grade
+0° to + 180° F
(-18° to +83° C)
10W
+0° to + 210° F
(-18° to +99° C)
10W-20, 10W30
+50° to + 210° F
(+10° to +99° C
20W-20
To order go to Discount-Equipment.com
To Next Page
Loading...
