Johnson Controls DWCR2 - Page 19

Wired Controller DWCR2
15
3.7.6 Save Function Setting
Enter user function page. Press “ “∧ ” or ∨” button to select save function and
press “
＜
” or “
＞
” button to turn on or turn off save function. Press MENU button to
enter save function setting page.
Enter the save function setting page, and press “
＜
” or “
＞
” button to select
cooling or heating limitation temperature. After selecting cooling or heating limitation
temperature, press ““∧ ” or ∨” button to adjust limitation temperature value. After
setting, press MENU button to save the setting.
Note:
When save function is set, auto mode cannot be set.
3.7.7 This section left intentionally blank
3.7.8 X-fan Function Setting
Enter user function page, press “∧” or “∨” button to select dry function option, and
press “
＜
” or “
＞
” button
to turn on or turn off this function with auto saving.
Note:
① This function is only available in cooling mode and dry mode;
② When this function is on, if the air conditioner is turned off, the indoor fan will
still operate at low speed for a while to dry the residual water inside the
unit.