Wired Controller DWCR2
16
3.7.9 Quiet Function Setting
Enter the save function setting page, and press “＜” or “＞” button to select
quiet function. Press “
＜
” or “
＞
” button to turn on or turn off this function with
auto saving.
Note:
This function is only available in cooling mode, heating mode, and auto mode.
3.7.10 Filter Clean Reminder Setting
Enter the save function setting page, and press “＜” or “＞” button to
select clean function option. Press “
＜
” or “
＞
” button to turn on or turn off this
function. Press MENU button to enter the setting page of filter clean reminder
function.
Enter setting page of filter clean reminder function. Press “∧” or “∨” button
to select pollution level. Press “
＜
” or “
＞
” button to set environmental level. Press
“∧” or “∨” button to select accumulating time setting and then press “
＜
” or “
＞
”
button to set required time. Press MENU button to save the setting.
When level 1 is selected, the adjusting range of accumulating operating time is
5500~10000 hours, with 500 hours in each increase or decrease.
When level 2 is selected, the adjusting range of accumulating operating time is
1400~5000 hours, with 400 hours in each increase or decrease.
When level 3 is selected, the adjusting range of accumulating operating time is
100~1000 hours, with 100 hours in each increase or decrease.
This function is used to remind you to clean the filter when the unit’s own
operating time reaches your setting.
To Next Page
Loading...
