Johnson Controls DWUNI User Manual

function is canceled automatically after setting.
This function is only available in cooling mode.
When this function has been set, set temperature is displayed in 81℉(27ć). In
this case, temperature setting and fan speed setting are disabled.
This function is canceled when turning off the unit or switching modes. This
function and sleep function cannot be on simultaneously. If I-Demand function is
set first and then Sleep function is set, I-Demand function is canceled while Sleep
function is valid, and vice versa.
Note:
If Fixed-angle swing function is not available for the connected unit, this
Ɣ
Ɣ
Ɣ
Ɣ
ƔThis function is only available in heating mode.
ƔWhen this function has been set, set temperature is displayed as 46℉(8℃)
( 46℉) . In this case, temperature setting and fan speed setting are disabled.
ƔThis function is canceled when switching modes.
ƔThis function and Sleep function cannot be on simultaneously. If Absence function
is set first and then Sleep function is set, Absence function is canceled while
Sleep function is valid, and vice versa.
3.7.5 Memory Function Setting
After entering user function page, press “
ġ
” or “
Ģ
” button to select Memory function
and press “
˘
” or “ ” button to turn on or turn off Memory function with auto saving.
3.7.6 Fixed-angle SWING (Louver) Mode Setting
3.7.4 Absence Function Setting
After entering user function page, press “∧” or “∨” button to select Holiday function
option and press “＜” or “＞
” button to turn on or turn off this function with auto saving.
This function is used to maintain indoor temperature so that unit can recover fast heating.
Note:
After entering user function page, press “
ġ
” or “
Ģ
” button to select Lock swing
function option and
press “
˘
” or “
˚
” button to turn on or turn off this function with auto
saving.
3.7.2 Health Function Setting
After entering user function page, press “
ġ
” or “
Ģ
” button to select health function
and press “
˘
” or “
˚
” button to turn on or turn off health function with auto saving.
3.7.3 I-DEMAND Function Setting
After ente
ring user function page, press “
ġ
” or “
Ģ
” button to select IDEMAND
function option and press “
˘
” or “
˚
” button to turn on or turn off this function with auto
saving.
Note:
Wired Controller DWUNI User Manual


Johnson Controls DWUNI Specifications

General

Brand	Johnson Controls
Model	DWUNI
Category	Controller
Language	English