Canada
This Class (A) digital apparatus meets all the
requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la Classe (A) respecte
toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
Installation
Observe the following guidelines when installing a
field controller:
• To minimize vibration and shock damage,
transport the controller in the original container.
• Verify that all parts shipped with the controller.
• Do not drop the controller or subject it to physical
shock.
Parts included
• One field Controller. (Power and SA bus terminal
blocks are removable)
• One installation instructions sheet.
Materials and special tools needed
• Three fasteners appropriate for the mounting
surface (M4 screws or #8 screws)
• One 23 cm (9.125 in.) or longer piece of 35 mm
DIN rail and appropriate hardware for DIN rail
mount (only)
• Small straight-blade screwdriver for securing
wires in the terminal blocks
FAC3613 physical features
Figure 1: FAC3613 Physical Features
Table 1: Physical features
Physical feature: description and references
1
Analog Output (AO) Terminal Block: Can be defined as
Voltage Analog Output (0–10 VDC) or Current Analog
Output (4–20 mA) (see Table 2)
2
Device Address DIP Switch Block (see Setting the Device
Addresses)
3 Mounting clip
Table 1: Physical features
Physical feature: description and references
4
Binary Outputs (BO) Terminal Block: 24 VAC Triac (see
Table 2)
5
24 VAC, Class 2/SELV Supply Power Terminal Block (see
Supply power terminal block)
6 Cover Lift Tab (One of Two)
7 FC Bus Terminal Block (see FC bus terminal block )
FAC3613 Advanced Application Field Equipment Controller Installation Guide2
To Next Page
Loading...
