Why is my Johnson Controls Controller showing 'Zone Temperature Too Hot'?
If the Johnson Controls Controller shows 'Zone Temperature Too Hot', verify that the TEC and the RTU cooling are enabled and functioning. This issue occurs when the zone temperature increases above the configured Zone Temp High Limit.
How to fix Touchscreen Unavailable on Johnson Controls Controller?
To address a touchscreen that is unavailable on the Johnson Controls Controller, try rebooting the controller. If the problem continues, order replacement units and return the affected devices to Johnson Controls under the RMA program. This issue occurs when the touchscreen components fail to initialize.
How to fix an unresponsive touchscreen on a Johnson Controls Fan?
If the touchscreen on your Johnson Controls Fan is unresponsive, it indicates that the touchscreen components have failed to initialize. First, try rebooting the controller. If the problem persists, order replacement units and return the affected devices to Johnson Controls under the RMA program.
How to troubleshoot a 'Supply Fan Fault' on my Johnson Controls TEC3000 Thermostat?
If your Johnson Controls Thermostat displays 'Supply Fan Fault', verify that the Supply Fan is operating when turned on and that the Supply Fan Status wiring is connected correctly.
How do I fix the slow temperature change on my Johnson Controls TEC3000 thermostat?
To fix the issue where the TEC3000 zone temperature doesn't change fast enough on your Johnson Controls Thermostat, select 'Control Setup > Tuning > Equipment Size > Oversized'.
How to adjust unoccupied mode temperature swings on my Johnson Controls Thermostat?
If the zone space temperature increases or decreases too much when the unit is active in unoccupied mode on your Johnson Controls Thermostat, decrease the 'Unoccupied Off Delay' parameter from 10 minutes to a more appropriate time for the equipment configuration.
Why can't my Johnson Controls Thermostat access my USB drive?
If your Johnson Controls Thermostat is unable to access a USB drive, reformat the USB drive, or try a different USB drive with a supported format (FAT for networked models, FAT16 for wireless models, and FAT32 for all models).
What does 'Zone Temp Unreliable' mean on my Johnson Controls Controller?
If your Johnson Controls Controller displays 'Zone Temp Unreliable', it means all sources of zone temperature, including the onboard sensor, are unreliable. You will need to order replacement units and return the affected devices to Johnson Controls under the RMA program.
What to do for 'USB Malfunction' on Johnson Controls Controller?
If the Johnson Controls Controller displays 'USB Malfunction', try inserting and using the USB drive again. If that doesn't work, try a new USB drive. If problems persist, order replacement units and return the affected devices to Johnson Controls under the RMA program. This issue occurs when a USB drive has malfunctioned and drawn more than the maximum allowed current.
What does 'Cooling Ineffective' mean on my Johnson Controls Controller?
If your Johnson Controls Controller displays 'Cooling Ineffective', it means the supply air temperature hasn't decreased enough while cooling has been active for the specified delay. To resolve this, verify that the cooling elements on the rooftop are functioning properly.
Guidelines for selecting the best placement for controller performance.
Step-by-step guide for physically installing the thermostat controller.
Warnings about shock hazards, property damage, and ESD during wiring.
Instructions for wiring terminals and setting the bus end-of-line switch.
Guide for using the USB port for upgrades, backups, and restoring settings.
Lists common faults, their causes, and recommended solutions.
Detailed steps to diagnose and fix specific operational problems.
General| Brand | Johnson Controls |
|---|---|
| Model | TEC3000 Series |
| Category | Thermostat |
| Language | English |
To Next Page
