English – 49
7
6
5
2
1
6017-225
6017-120
6017-226
8009-123
6017-227
Lift off the drive belt (1). Now pull out the split pin
(2). Observe caution to avoid trapping your hand.
Pull the frame forwards and refit the pin.
If the cylindrical bolt, which is now holding the
cutting unit, is removed, the cutting unit can be
lifted off.
Releasing the Service Position
To release the service position, reverse the proce-
dures set out in Placing in the Service Position.
Make sure that the cutting unit’s lug enters the loop
correctly on the underside of the machine, see
illustration.
Grasp the cutting unit’s front edge, pull out and lift
up into the service position.
Or:
Repair Instructions
To Next Page
Loading...
