English – 47
2
8009-265
8009-028
8009-280
8009-281
Repair Instructions
1
Adjusting the Cutting Height Area
Remove the right wing cover.
Raise or lower the entire cutting area by screwing
the nuts up or down.
If the highest cutting height is raised by 5 mm, the
other fixed cutting heights will also be raised an
equal amount.
• Loosen the nut on the height adjustment strut.
• Adjust so that the distance between the stop for
lowest height setting and the protective frame is
5 mm.
• Tighten the nut.
• Recheck that the parallelism has not changed. If
so, the parallelism must be readjusted.
• Check and if necessary adjust the cutting unit’s
ground pressure, see Checking and Adjusting
the Cutting Unit’s ground pressure.
• Attach the nose cover.
IMPORTANT INFORMATION
When changing the cutting unit, you must
readjust the parallelism and cutting height.
Adjusting the Cutting Height
To Next Page
Loading...
