Jorvik Jet-E1 - Page 39

Jorvik JMT Mid Drive Electric Mountain Trike
Page | 39
will nd a wire that goes into the lever body.
slacken the grub screw with the hex key. With
the 8mm spanner unwind the nut ¼ turn (do this
on each side). Check to see if brake light has now
turned o. Now pull the brake to check that the
light comes on. Tighten the grub screw.
Thumb lever not returning
when released
Scky switch.
Turn o the e-system. Using a contact cleaner
spray or PTFE base spray lubricant give a short
squirt into the thumb lever assembly. Wait for a
few minutes and move the lever icking it to
move the lubricant through the housing. Turn on
and check that the thumb lever works. If it sll
will not release or fails to operate walk assist,
contact a local E-bike shop for a diagnosc. A
replacement switch may be required.
My tricycle got very wet and
won’t turn on.
Water in connecons or
components.
Unplug the baery and towel dry outside. Spray
contact cleaner or water disperser on the
connecon port. Leave in a dray warm place for
24 hours.
Undo all connecons and spray water disperser
into the connecon and leave unplugged. Towel
dry all cables, plugs and tricycle. Store the