02 J4C SERIES
HANDBOOK_J4C SERIES 05
INDEX
J4C Electric actuators operate with the use of live electricity. It is recommended that only qualified
electrical engineers be allowed to connect or adjust these actuators.
READ THESE INSTRUCTIONS BEFORE CONNECTING THE ACTUATOR. DAMAGE CAUSED BY
NON COMPLIANCE OF THESE INSTRUCTIONS IS NOT COVERED BY OUR WARRANTY.
Warning: Ensure that the square rubber seal is in place when fixing each
DIN plug to the actuator. Failure to do so could allow water ingress and
damage caused by this installaon error will invalidate any warranty. The
DIN plugs are fixed to their respecve bases on the actuator housing with
a screw. Do not over ght the screw (8) when assembling (Max. 0.5Nm ).
1. Gasket
2. Terminal strip
3. Cable fixing screws
4. Housing
5. Washer
6. Grommet
7. Gland - nut
8. Fixing screw
9. Washer
10. Gasket
All our actuators model S20 to S300 are ready to work from 24-240VAC / 24-135VDC.
All our actuators model B20 to B300 are ready to work at 12 VDC/VAC ONLY.
All our actuators model H20 to H300 are ready to work from 85-240VAC/VDC.
VOLTAGE TO BE CONNECTED
Warning: Before connecng ensure that the voltage to be applied to the actuator is within the range
shown on the idenficaon label. The supplied electrical connectors, used to connect to the actuator
are DIN plugs. Ensure the diameter of cable to be used conforms to the maximum and minimum
requirements of the DIN plugs to maintain water ghtness (Fig.1).
ELECTRICAL CONNECTORS
To Next Page
Loading...
Need help?
General
