J+J J4C S20 - NC Set-Up; NO Set-Up

HANDBOOK_54
 SELDIR
NC Set-Up
NC - If, in case of a power supply
failure, we need the actuator go to
the CLOSE posion, we need to put
the jumper 1 on the SELDIR
posion.
(*) NO or NC Set-Up
NO Set-Up
NO - If, in case of a power supply
fail- ure, we need the actuator go
to the OPEN posion, be sure that
the jumper 1 is not on the SELDIR
posion.
