HANDBOOK_62
PIECES
A - 1 Cover
B - 1 Plasc column
C - 1 DPS posioner PCB
D - 2 Sheet metal Fixing screws
E - 1 Plasc Fixing screws
F - 1 Schemac diagram label
A
C
D
E
F
B
PLEASE READ CAREFULLY BEFORE MOUNTING.
VERY IMPORTANT!!!! PLEASE FOLLOW THE INSTRUCTIONS STEP BY STEP. BEFORE CON-
NECTING “A” PLUG TO THE ACTUATOR, CHECK THAT THE VOLTAGE IS THE SAME AS THE
ONE SPECIFIED ON THE LABEL (CARTER).
TO CONVERT A STANDARD (ON-OFF) J4C ELECTRIC ACTUATOR INTO A MODULATING
FUNCTION WITH POSITIONER, PROCEED AS FOLLOWS:
The unit must be disconnected from any electrical power or signal before installing.
(Fig.2A and 2B)
(Fig.3)
(Fig.4)
(Fig.5A, 5B & 5C)
(Fig.6)
(Fig.7A,7B & 7C)
(Fig.8A, 8B & 8C)
(Fig.9)
(Fig.10)
(Fig.11A)
(Fig.11B).
(Fig.12)
(Fig.13)
(Fig.13A and 13B)
To Next Page
Loading...
