To Next Page

To Previous Page

YDFLP-E-80&100-M7-M-R User Manual

File Number: JG-MCYF-SM-0039

Figure 18 Setting parameters and emitting

After selecting full control mode, user can set power, frequency, pulse width and then

press “edit” button to confirm. User can switch on/off emission when clicking “Laser” button.

Note: All the parameters except power can’t be modified during emission.

3 Control MO signal

Figure 19 GUI control MO state

Ctrl MO: The “MO” button will be appeared on the interface after selecting Ctrl MO. User

can control the switching of MO signal while clicking this button. This setting will not be

preserved after power off.

2)Default parameter setting and selection

① Selecting red beam/laser priority mode

Figure 20 Selection Red Beam/ Laser Priority Mode

Questions and Answers:

Need help?

Do you have a question about the JPT YDFLP-E-80&100-M7-M-R and is the answer not in the manual?

JPT YDFLP-E-80&100-M7-M-R Specifications

General