Chapter 3 INSTALLATION OF THE DISPLAY UNIT
3.10 POWER SUPPLY (OPTION)
3-30
NBD-865
Note:
This cannot be used with the following scanners.
・NKE-2062HS
・NKE-2063HS
・NKE-2103-4/4HS/6/6HS
The power supply can be used commonly with the ship's mains 100-120 VAC and
200-240 VAC, however, you need to connect to proper connector.
Open the cover on the rear of the power unit, then connect to proper connector.
When 100 V series are used, connect to "AC100-120V" connector.
When 200V series are used, connect to "AC200-240V" connector.
To Next Page
