BASIC OPERATION
After performing the
SET
operation, the central display will indicate the frequency band
that corresponds to the new settings. Always verify that the the exciter frequency matches
the indicated band setting of the
JRL-ZOOOF,
and that the proper antenna is selected.
Also verify that the antenna
VSWR
matches the exciter's transmit frequency by turning
the PA switch
OFF
and keying the exciter. The MATCH
LED
should light green, indicating
a
VSWR
of
1.51
or lower. If the MATCH
LED
is orange or red, see the "Supplements"
section below.
Supplements
When the forced transmission signal line is not connected:
Because the exciter will not automatically enter transmission mode, manually key the exciter
to begin transmission. If the
SSB
mode is selected, speak a few words into the microphone.
The
JRL-2000F
measures the operating frequency.
When
B
is indicated in the central display:
This indicates that there is not sufficient input power to perform the automatic tuning operation.
Adust the power output control of the exciter to increase the drive level. The
JRL-2000F
can not perform the
SET
operation unless there is more than approximately
30
W
input.
When the color of the
MATCH
LED
is orange or red:
This indicates an error in the stored preset data and proper antenna matching has not
been achieved. Please refer to section
6.3
and implement the automatic tuning operation.
To Next Page
Loading...
