JUKI DDL-900B - Adjustment of the Pedal; Marker Dots on the Handwheel

– 19 –
(1) Installing the connecting rod
1) Move pedal ❸ to the right or left as illustrated
by the arrows so that motor control lever ❶ and
connecting rod ❷ are straightened.
(2) Adjusting the pedal angle
1) The pedal tilt can be freely adjusted by changing
the length of the connecting rod ❷.
2) Loosen adjust screw ❹, and adjust the length of
connecting rod ❺.
28. Adjustment of the pedal
WARNING :
Be sure to turn the power OFF before the following work in order to prevent personal injury due to
unintentional starting of the sewing machine.
29. Marker dots on the handwheel
Check the marker dots on the handwheel with the
presser foot lifted after thread trimming.
・ The upper stop position of the needle bar is
reached when marker dot ❶ on the cover is
aligned with blue marker dot ❷ on the handwheel.
・ The operating timing of the thread trimming cam
is when marker dot ❶ on the cover is aligned with
green marker dot ❸ on the handwheel.
❶
❷
❺
❸
❹
❷
(Blue)
❸
(Green)
❶