EasyManuals Logo

JUKI DDL-900B User Manual

JUKI DDL-900B
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
– 4 –
2. Installing the pedal sensor
1) Install the pedal sensor to the table with mounting
screws supplied with the unit.
It is necessary to install the pedal sensor at such
a position that the connecting rod is perpendicu-
lar to the table.
2) After the completion of installation of the pedal
sensor on the table, place the sewing machine
head on the table.
1ø 220V-240V
3. Installing the power switch (for CE)
Do not insert the power plug into the plug
receptacle.
1
) Remove screw on the side face of the power
switch cover to open the power switch cover.
Blue Blue
Brown Brown
Green/
Yellow
Green/
Yellow
2) Pass AC input cord (40145128),
(M6102461DAA) through the rear face of the
power switch. Bundle the cord with cable clip
band to secure it.
3) Securely x the terminals of the AC input cord
(40145128), (M6102461DAA)
by tightening
the screws at the specied locations.
4) Close the power switch cover. Tighten screw
on the side face of the power switch cover.
WARNING :
1. Be sure to attach the ground wire (green/yellow) to the specied location (on the ground side).
2. Take care not to allow terminals to come in contact with each other.
3. When closing the power switch cover, take care not to allow the cord to be caught under it.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JUKI DDL-900B and is the answer not in the manual?

JUKI DDL-900B Specifications

General IconGeneral
BrandJUKI
ModelDDL-900B
CategorySewing Machine
LanguageEnglish

Related product manuals