– 24 –
(3) Constant-dimension stitching pattern
The constant-dimension stitching pattern can be set.
[How to set the constant-dimension stitching]
• Straight stitching
1) Press switch ❼ to select the constant-dimension sewing pattern.
When the constant-dimension stitching pattern is enabled, LED Ⓖ lights up.
2) When the constant-dimension sewing pattern is selected, the number of stitches of process E can be set
by pressing switch ❼ again.
3) The number of stitches (0 to 999) for the constant-dimension stitching can be selected by pressing
and switches ❾.
• Label sewing
1) Press switch ❽ to select the label sewing.
When the selection is effective, LED Ⓗ lights up.
Every time switch ❽ is pressed, the indication of processes E to H will be changed over.
2) Display the target process the number of stitches of which is to be changed. In this state, the number of
stitches of the processes (EFGH) can be changed by pressing and switches ❾.
To Next Page
Loading...
