KE-2070/2080 MS Parameter
1-4. MS parameter storage locations
The MS parameter is saved in the "D:¥Juki¥Data" folder.
The following shows the file names and functions (Sample for KE-2070).
CTL2070S.DAT Mechanical control parameters
DSN2070S.DAT Design dimensions, such as nozzle length and height
MPD2070S.DAT Design coordinate values related to mechanical units of the machine
MSP2070S.DAT MS parameters
OPT2070S.DAT Information on optional units and optional operations
POS2070S.DAT Assembly dimensions related to mechanical units of the machine
SUP2070S.DAT Machine setup information
Additionally, backup MS parameters are saved into FLASH ROM on the BASE-FEEDER
board.
To save the MS parameters, follow the steps below to create a backup file on a floppy disk.
1-4-1 Saving the control data into a backup file
c Select [Control Data Management...] from the [File [F]] menu.
d The Control data files storage wizard will appear. In this window, check on [2.
Backup control data to disk] and click [Next].
1-5
Rev. 1.00
To Next Page
Loading...
Need help?
General
