KE-2070/2080 MS Parameter
2-4. Z move
If you select [Z move (Z)...] from the control menu, the following [Z moves to a given
coordinate] dialog box will appear.
Select a desired head you wish to control from the combo box.
This selection does not affect the settings in "Units in use" of the machine setup. (It is
possible to select even a unit, which is not checked on (not in use).)
Press the Alt and ↓ keys at the same time. The following list will appear.
(KE-2070) (KE-2080)
Input a coordinate in the [Moving target position] field and select the [MOVE] button or
press the F3 key to move the Z-axis of the head you have selected to the specified coordinate
position.
Before lowering the Z-axis, make sure that the feeder and conveyor
rail are not located under the Z-axis. If you start lowering the
Z-axis above the feeder or other unit, the Z-axis may collide with
the feeder, causing damage to the machine.
CAUTION
2-3
Rev. 1.00
To Next Page
Loading...
