JUKI KE-2080 - Light Setting; Nozzle up Cylinder

KE-2070/2080 MS Parameter
2-7. Light setting
If you select [Light setting (I)] from the control menu, the following [Light setting] dialog
box will appear.
You may set a type of light to be lit and bright level (%) necessary for the VCS illumination
control.
You cannot set the bright level for lights not to be lit (checked off).
If you select [OK], the VCS lights are lit with set contents when selecting the VCS
illumination control next time.
If you select [CANCEL], the set contents become invalid.
2-8. Nozzle up cylinder
If you select [Nozzle up cylinder (H)] from the control menu, the following [Nozzle up
cylinder] dialog box will appear.
If you select <ON (O)>, <OFF (O)>, or <ON/OFF (G)> in the servo OFF status, you can
control the nozzle up cylinder.
You cannot control the nozzle up cylinder in the servo ON status.
2-5
Rev. 1.00