KE-2070/2080 MS Parameter
2-5. Conveyor control
If you select [Conveyor control...] from the control menu, the following [Control of
conveyor] dialog box will appear.
Input a thickness of PWB and select the [Exec.] button or press the F3 key to run the control.
2-6. Light map
If you select [Light map (L)] from the control menu, the following [Light map control]
dialog box will appear.
Select a direction and input a line No., and then select the [Exec.] button or press the F3 key.
The light map at the specified position is then obtained.
Auxiliary functions
F5 key: Executes the light map with the current line No. incremented.
F6 key: Executes the light map with the current line No. decremented.
2-4
Rev. 1.00
To Next Page
Loading...
