KE-2070/2080 MS Parameter
1-5. Basic operation
1-5-1. Updating the data
When obtaining each data, the newly set (changed) data will become valid when selecting
[OK] to complete the data setup.
The offset coordinate values become valid after the home position return has been
completed.
Therefore, when only data is changed, this change is not valid. Pay special attention to this
point.
Additionally, if you select [Cancel], the changes you have made become invalid.
1-5-2. Limitations
• The [ORIGIN] switch is invalid on the data change screen. Before starting the home
position return, close the change screen to return to the initial screen.
• The [STOP] switch is invalid on the data change screen. You must wait until the
machine is stopped or stop the machine with the EMERGENCY STOP switch.
1-14
Rev. 1.00
To Next Page
Loading...
