KE-2070/2080 MS Parameter
g If you have changed any MS parameter, the following message will appear when
exiting the MS parameter.
To save the MS parameter values, click [Yes]. To keep the previous values before
running the MS parameter, click [No]. To continue the MS parameter, click
[Cancel].
h Subsequently, the message prompting you to reset I/O will appear. Normally, click
[Yes] unless an interference with other unit is predicted as the head is moved
smoothly.
1-3. Configuration
The MS parameter operation menu is classified into three groups, Initial set-up, Offset
set-up, and Others.
• Initial set-up: This setup is used when installing the machine. For details, see Chapter 3.
• Offset set-up: This setup is used when replacing a mechanical part. For details, see
Chapter 4.
• Others: This setup is used to copy the operation program to each board when
replacing the BASE-FEEDER board, I/O CPU board, or IPX-3 board.
For details, see Chapter 5.
If you press the right mouse button or F9 key, the Control menu will appear. For details, see
Chapter 2.
1-4
Rev. 1.00
To Next Page
Loading...
