KE-2070/2080 MS Parameter
[3] Initial set-up
CAUTION
The initial setup needs to be changed only when JUKI instructs to
change the settings.
If the changed contents do not meet the specifications, the correct
operation cannot be guaranteed.
3-1. Machine specifications
3-1-1. Function
You may set the following items.
No. Item Set contents
1 Transport reference plane Reference plane of machine
2 Transport direction Transport direction of machine
3 Component height Maximum height of component
4 PWB type PWB type
5 Machine type option Settings for optional machine types
3-1-2. Required jig
This setup requires no jigs.
3-1-3. Operation
If you select [Mech specifications (C)...] from the [Initial set-up (I)] menu, the following
[Conveyor specifications] dialog box will appear.
Check on relevant radio buttons to select desired items.
If you change the conveyor specifications, you need to initialize the coordinates of the MS
parameter and machine setup.
Additionally, the component height you can select may vary depending on the machine
model.
KE2070: SC (6 mm), NC (12 mm)
3-1
KE2080: NC (12 mm), HC (20 mm),
EC (25mm)
If you select [OK] after you have
changed the conveyor specifications,
the following message box will appear,
prompting you to change the unit
assembly position.
Rev. 1.00
To Next Page
Loading...
