−38 −
Installing procedure
◯ Removing procedure
1) Removing the side plate
1. Loosen setscrews ① in the side plate B located at the anti-operator’s side of the machine arm.
2. Remove side plate B ② .
3. Remove side plate B gasket ③ .
2) Removing the reverse feed control lever
1. Loosen the respective setscrews in the belt cover and remove the belt cover.
2. Remove setscrew ④ in the reverse feed control lever.
3. Remove reverse feed control lever ⑤ .
Removing parts list
(Caution) 1. Parts with ★ mark are parts which are used even after replacement.
2. Part with ※ mark is an exclusive part for the machine without automatic reverse feed
device.
3) Installing the reverse feed link hinge screw
1. Remove feed driving rocker tension spring ① .
2. Loosen felt presser setscrews ② and remove felt presser ③ .
3. Loosen setscrew ④ in the feed rocker link pin and remove feed rocker link pin ⑤ .
4. Remove feed rocker link ⑥ from feed driving rocker ⑦ .
5. Loosen the setscrew in the feed driving rocker support and move feed driving rocker support to the right
or left.
6. Draw out the feed driving rocker.
7. Install reverse feed link hinge screw ⑩ and nut ⑪ to feed regulator connecting rod ⑨ .
8. Install the above parts by reversing the above order.
◎ Attaching parts list of the reverse feed link hinge screw (List 1)
Note No. Part No. Name of part Q’ty
★ 1 SS4110815SP Side plate B setscrew 5
※ 2 21331806 Side plate B 1
★ 3 21332002 Side plate B gasket 1
4 SS6120930SP Reverse feed control lever setscrew 2
★ 5 22610505 Reverse feed control lever 1
Note No. Part No. Name of part Q’ty
10 NS6150430SP Reverse feed link hinge screw nut 1
11 SD0800402TP Reverse feed link hinge screw 1
To Next Page
Loading...
Need help?
General
